She went limp...

[Gomer_pyle]

Well I had my displacer blow out on me a while back. Got her swapped out with another one. If that counts for anything. But the right corner is lower than the other side is. What can I do to fix this? I was thinking about fitting a shim. But not sure if that will work. Also it was like this before the original displacer went out.

Heres a few pics.

Front Right
http://img.photobucket.com/albums/v705/gomer_pyle009/DSCN0750-1.jpg

Front Left
http://img.photobucket.com/albums/v705/gomer_pyle009/DSCN0751-1.jpg


If It counts for anything the rear and both sitting at the same height.

Thanks
-Andy

[Cheleker]

Start by having both sides pumped up properly to use as a base line. If the RF is still low I'd suspect the RF knuckle joint. What was it like when you replaced the displacer?

[MrBoring]

A magic wand and a bottle of viagra if the knuckle joint doesn't fix it.

[Gomer_pyle]

Where exactly is the knuckle located and im guessing it involves pumping down the right side to get to it.

[Cheleker]

The knuckle joint is a ball and socket arrangement on all four corners. You had to deal with it when you replaced the front displacer. On the front it is a ball fitting into a plastic/nylon-type cup that in turn fits into the upper arm.
And, yes, you'll have to depressurize the system to get to it.