HS4 intake manifold

[Dixminion]

I find myself in need of a single carb intake manifold to go with the Freeflow Maniflow exhaust header on a 998. Hoping for 1 1/2" diameter, HS4 diagonal bolt pattern, with coolant pipe. If it has some cool speed equipment name cast into it all the better!
Don

[James T]

Check with Mark H. He had one for sale last summer when I was looking the the same thing.

[Mark]

Sorry, It's been sold. Thanks for the heads up referral in my direction though.
:beer:
Best regards,
MSH

[Dixminion]

Thanks Guys,
At the risk of much ridicule I'm also considering cuting the original cast steel intake/exhaust apart. I have doubts if the newly freed intake will clear the center branch of the Maniflow. Anyone willing to admit experience with this setup?
Don

[Cheleker]

Haven't done so with that set up, but remember to check clearance with any HS4 manifold (there are some that won't clear a freeflow or LCB); to check flange thickness between the exhaust and intake manifold (they should be close); and to check the angle the intake makes with the head. There will be tears at bedtime if you end up with an inline engine manifold.

[James T]

I think I might have one of those, If so, you can have it.

[Dixminion]

Thanks James, Will you bring it up to the White Elephant? Don

[James T]

Yep